OEM 800mm 2000W Carbon Fiber Heating Lamps with SK15 Connectors: Specs and Real-World Use
We built this 800mm, 2000W carbon fiber heating lamp for engineers who just need a heat source they can trust. You need intensity. You need it fast. And you need it in a size that fits without forcing you to redesign the whole setup.
What makes it work
The 800mm length and 2000W power are tuned to give you a steady heat profile across a set zone—without pushing the system too hard. It’s sized to drop right into typical industrial heater bays, so installation stays straightforward. That power density also means you get a rapid temperature rise, which can help you shorten cycle times on the line. One thing to get right from the start: voltage. This lamp is engineered for a specific operating voltage, and the carbon fiber element is set to deliver 2000W at that voltage. If you run it on a mismatched supply, you’ll either underperform or risk overheating. So plan your control circuit accordingly—match the voltage, and you’re set.
The build, explained simply
At the heart is a carbon fiber heating element, wrapped in a quartz envelope. Carbon fiber brings the speed—fast ramp-up, even heat distribution. Quartz handles the heat shock and stays stable when temperatures climb. And we finish the lamp with an SK15 connector—a two-pin ceramic design built for high-temperature terminals. The reason we chose SK15 isn’t about convenience. It’s about keeping the connection solid when it’s hot and the machine is vibrating. It helps reduce hot-spot resistance and prevents connector failure during continuous operation.
Where it shines
This lamp is ideal for industrial heating, curing, and drying—anywhere you need focused infrared heat. The 800mm form factor gives you a useful heating width, and the 2000W output gives you the heat flux needed to hold consistent process temperatures. You get fast start-up, stable output, and wiring that stays clean thanks to the SK15 termination.
The one thing to plan for
High power density is a strength—but it also needs respect. Make sure your machine has adequate cooling and proper thermal shielding. If your enclosure is tight, size your heat management before you wire anything up.
Built to drop in and deliver
This lamp is designed as a true OEM component. It’s meant to be spec’d into your equipment with performance you can count on and installation that repeats, job after job.